Beam 7R - Product Presentation; DMX Connection

230W moving head beam light user manual
2 / 14
in a damp or leaking place, and the temperature should not exceed 60 degrees
Above environmental work.
 When the bulb is used, the change of supply voltage should not exceed ±10%, the
voltage is too high, which will shorten the life of the bulb, and if the voltage is
too low, it will affect the light color of the bulb.
 After power outage, it takes 20 minutes to fully cool the lamp before it can be
powered on again.
 The lamp rotating and pasting accessories must be checked regularly, loosened,
shaken and strengthened in time to prevent accidents.
 Please read this note carefully to ensure the normal use of the product.
1.4 Product presentation
 Light source power：260W；
 power supply：AC 200V~240V/50~60Hz;
 Color wheel:Each color wheel consists of 13 color slices + white light;
 Gobo wheel:18 gobos;
 540° of pan movement,270° of tilt movement.
 Intelligent thermal protection protection;
 Control mode: DMX512/ master-slave/Auto-run;
 IP20 protection grades.
1.5 DMX connection
The fixture is equipped with both 3-pin or 5-pin XLR sockets for DMX input and
output.Please use the twisted pair signal line specially shielded for DMX 512.The
signal line is generally connected at a distance of 150m. When the long distance
signal is transmitted, the DMX512 signal amplifier must be added.
Use a shielded twisted pair signal line to connect from the controller's DMX output to
the DMX input of the first device,And connect from the DMX output of the first
device to the DMX input of the second device,by parity of reasoning,Until all the
lamps and lanterns are connected,Then install a terminal plug on the last connecting