Beam 7R - Troubleshooting

230W moving head beam light user manual
14 / 14
4. TROUBLESHOOTING
It is recommended some solution for some normal trouble shooting. Any
inextricable problems should always be handling by the professional person.
Disconnect the power supply before maintenance the light.
1. LAMP OFF
 Please check if install the suitable voltage
 Please check whether the power supply will reach the end of their life can
explode,please replace a same description power supply.
 Please check if the power supply is enough.
 Please check whether the DMX 512 controller pass the "turn on" order.
2. The light couldn't accept the control order
 Please check the start code address and the function option are correct.
 Please check whether the communicate control cable is on good connection
or the cable is too long or interrupt.
 Please check the control system is not valid, check the signal amplifier of
chain connected is valid.
 Please check whether the communicate cable is too long or the other
equipment is mutually conjugate.
 Please arrange the wire well, shorter the signal cable, put the high voltage
cable and low voltage cable separately.
 Add the signal amplifying isolator.
 Signal cable is used the excellent screening doublet.
 The end of the light end and the end resistance(120OHM).
3. The light can't move
 Please check if the power supply is suitable for the light voltage data.
 Please check the light if they are deformation, inside parts is broken, become
wet etc will lead the loose contact.
 Please check the if the inside lead wire and the connector is loose.
 Please check the electric parts(such as the transformer,PCB board,controller)
is short-circuit or burn down.
4. on working,the pan&tilt couldn't work normally
 Please check according to the above step by step.
 Please check the belt of the X/Y is broken.
 Please check the X/Y direction data to the receiver is damage.
 Re-projector reset.