In Activity mode, you can control two or more devices at the same
time.
The Beam remote has four Activity modes that combine different
devices; each mode has different options that can be selected from
the Beam app or programmed from the remote itself.
Customizing Activities
You can change the default Activity settings, by either using the Beam
app (recommended), or following the steps below.
1. Press and hold the PROGRAM button of the Beam remote until
the POWER button lights up solid red.
2. Press the Activity button you want to set, and it will light up. The LED
of the POWER button turns off.
3. Press the 1,2, or 3 button on the Beam remote, based on the desired
preset number combination (see next page).
4. You’ll hear a long beep confirmation, and the LED of the Activity
button will turn off.
NOTES:
• Some TVs may require the navigation and enter buttons for input — in
that case you will need to exit the “watch tv” mode and press “TV” in
DEVICE CATEGORIES.
• You can press the PROGRAM button to exit anytime.
ACTIVITIES
WATCH TV
STREAM
WATCH MOVIE
PLAY MUSIC
14
To Next Page
Loading...