— 10 —
3.5 Beam Position:
Once the laser is set-up in either horizontal or vertical leveling mode, if
the rotation speed of the laser is slowed to 0 rpm or the laser is placed in
scan mode, the positioning of the beam can be adjusted clockwise or
anti-clockwise by using the relevant beam position buttons.
3.6 Anti-Drift System:
Once the laser is set-up in either horizontal or vertical leveling mode,
pressing the anti-drift button will activate anti-drift mode. The anti-drift
LED will flash slowly when the anti-drift system is turned on. If the unit is
bumped or moved out of level when anti-drift is engaged, the anti-drift
LED will flash quickly and the laser will stop rotating. To deactivate
anti-drift mode, press the anti-drift mode button again.
3.7 Manual Grade:
• Set up the laser in horizontal leveling mode as above.
• When self-leveling has completed, press the auto/manual button to
enter manual mode.
• Press and hold the ¡ button to drive the beam up to your desired grade
in the X1 direction.
To Next Page
Loading...
Need help?
General