BeBook E-READER - Frequently Asked Questions (FAQ); Troubleshooting Power and Update Issues

28
Frequently Asked Questions
Q: My BeBook won’t turn on or freezes at the same page.
Whenthishappens,thelastscreencontentoftheBeBookwill
remaindisplayed.
A:Mostcommoncause:thebatteryisat.
Solution:
− ConnecttheUSB(power)cabletoyourBeBook.
− Pressthesmallresetbuttononthebackand/orpresstheon/off
buttonontopofthedevice.
− Chargethebatteryforuptofourhours.
Q: I tried to update the software/rmware, now my BeBook
freezes at the same page.
Or, during the update nothings happens for at least 10 minutes.
Or, I get a message stating: “invalidate le”
A:Mostcommoncause:thebatterywentatduringtheupdate,or
therewasaproblemwiththeSDcard.
Solution:
− CheckiftheSDcardusedissmallerthan256Mb(a128MbSD
cardprobablywon’twork)andnohigherthan1Gb(notallGb
cards,2Gbandlargercanperformtheupdate).
− UseasuitableSDcard,preferablya1GBcardcanbeusedto
storebooksaftertheupdate.
− ConnecttheUSB(power)cabletoyourBeBook.Pressthesmall
resetbuttononthebackand/orpresstheon/offbuttonontopof
thedevice.(KeeptheUSBcableconnected)