r Release the frequency setting (channel selection only)
Call up function SF 5 using the MDE key (4). The following displays
appear :
left LC display (7) SF 5
right LC display (8) ON or OFF
Select the required function using the kHz switch (10) and store the
function by pressing the STO key (3).
OFF = Frequency setting not possible.
The VHF transceiver can only work on the frequencies
stored in the individual channels.
ON = Frequency setting possible (standard setting).
r Release the frequency storage
Call up function SF 6 using the MDE key (4). The following displays
appear :
left LC display (7) SF 6
right LC display (8) ON or OFF
Select the required function using the kHz switch (10) and store the
selection by pressing the STO key (3).
Page 24 Issue 10/95
Operating Instructions
5 Exchange key Mode 2:
Exchange of preset frequency and
active frequency.
6 LE diode, green Transmit indication (PTT button pres-
sed).
7 LC display Indication of active transmission/
reception frequency (active frequen-
cy).
8 LC display Indication of preset transmission/
reception frequency (preset frequen-
cy).
CH indication steady :
Indicates the storage channel.
CH indication flashes :
If the initiated storage operation is
not completed by pressing the store
key.
9 Frequency selector Switching the indicated switch
switch frequency in 1 MHz steps or the
storage channel upwards or
downwards in steps of 10.
10 Frequency selector Switches the indicated switch
switch frequency in 25 kHz steps or the
storage channel by 1 step in each
case upwards or downwards, without
carry over.
Issue 10/95 Page 9
Becker AR 3209
To Next Page
Loading...
