Becker Centronic EasyControl EC541-II User Manual

Centronic EasyControl
EC541-II
Becker-Antriebe GmbH
Friedrich-Ebert-Straße 2-4
35764 Sinn/Germany
www.becker-antriebe.com
4034 630 201 0c03.05.2017
de
Montage- und Betriebsanleitung
Handsender
Wichtige Informationen für:
• den Monteur / • die Elektrofachkraft / • den Benutzer
Bitte entsprechend weiterleiten!
Diese Originalanleitung ist vom Benutzer aufzubewahren.
en
Assembly and Operating Instructions
Hand-held transmitter
Important information for:
• Fitters / • Electricians / • Users
Please forward accordingly!
These instructions must be kept safe for future reference.
fr
Notice de montage et d’utilisation
Télécommande
Informations importantes pour:
• l'installateur / • l'électricien / • l'utilisateur
À transmettre à la personne concernée!
L'original de cette notice doit être conservée par l'utilisateur.
nl
Montage- en gebruiksaanwijzing
Handzender
Belangrijke informatie voor:
• de monteur / • de elektricien / • de gebruiker
Aan de betreffende personen doorgeven!
De gebruiker dient deze originele gebruiksaanwijzing te bewaren.

Becker Centronic EasyControl EC541-II Specifications

General

Frequency	868.3 MHz
Channels	5
Modulation	FSK
Output Power	10 mW
Operating Temperature	-10°C to +55°C
Type	Transmitter
Frequency Range	868.0 MHz to 868.6 MHz
Power Supply	3V DC (2 x AAA batteries)

Summary

Assembly and Operating Instructions

General

Explanation of Pictograms

Warranty

Safety Instructions

Intended Use

Explanation of Displays and Buttons

Explanation of Functions

Channel

Transmitter channels can be programmed for one or multiple receivers, allowing individual or group commands.

Channel Indicator Lamp

Indicates radio signal; flashes when battery is low. Transmission strength and range decrease as battery power declines. Replace battery if lamp no longer lights up.

Programming the Transmitter

Programming the Master Transmitter

The first transmitter programmed into a receiver. Enables setting limit positions and managing other transmitters. Requires UP, STOP, DOWN, and programming buttons.

Programming Additional Transmitters

Steps to program additional transmitters after the master transmitter has been set up. Receiver confirms successful programming.

Installing the Wall Bracket

Changing Batteries

Cleaning

Technical Data

What to Do If...?

Simplified EU Declaration of Conformity