Becker B-Tronic EasyControl EC5415B User Manual

B-Tronic EasyControl
EC5415B
en
Assembly and Operating Instructions
Wall/hand-held transmitter, 15-channel,
bidirectional
Important information for:
• Fitters / • Electricians / • Users
Please forward accordingly!
These instructions must be kept safe for future reference.
Becker-Antriebe GmbH
Friedrich-Ebert-Straße 2-4
35764 Sinn/Germany
www.becker-antriebe.com

Becker B-Tronic EasyControl EC5415B Specifications

General

Frequency	868.3 MHz
Output Signal	Digital
Operating Temperature	-10°C to +50°C
Housing Material	Plastic
Type	Hand-held transmitter
Range	up to 100m
Compatibility	Becker receivers
Channels	15
Power Supply	Battery

Summary

Safety instructions

Explanation of displays and buttons

Normal/master mode

Programming the first transmitter

Receiver programming mode setup

Details the initial steps to prepare the receiver for programming.

Transmitter programming

Pairing new transmitter

Outlines the process of pairing a new transmitter with the receiver.

Changing receiver mode

Programming more transmitters

Adding multiple transmitters

Instructions for adding multiple transmitters to a receiver.

Receiver programming via radio switch

Deleting transmitters

Delete from multi-transmitter receivers

How to remove transmitters when multiple are paired with a receiver.

Delete from single-transmitter receivers

Setting tubular drive limit positions

Changing rotation direction

Instructions to correct the motor's movement direction if it's reversed.

Set upper and lower stop limits

Set upper and lower travel points

Set upper stop to lower point

Set upper point to lower stop

Deleting limit positions

Delete individual limit positions

Delete both limit positions

Intermediate positions I + II

Setting intermediate positions

Deleting intermediate positions

Programming run times

Deleting run times

Upper anti-freeze mechanism

Activating/Deactivating anti-freeze mechanism

Fly screen protection function

Activating/deactivating repeater mode

Reset transmitter to factory settings

Scenarios

Calling up a scenario

Stopping a scenario during execution

Calling up a different scenario

Deleting a scenario

Changing batteries

Troubleshooting