Flashes
yellow six
times
Receiver mode roof window
Repeat this procedure until the desired receiver mode has been selected.
Programming more transmitters
Programming more B-Tronic transmitters in the B-
Tronic receiver
Ready the receiver for programming in one of the three possible ways.
Please make sure that only one receiver is in programming
mode at any time. It is not possible to program/clear multiple
receivers at the same time.
Readying the B-Tronic receiver for programming with a programmed
B‑Tronic transmitter
Put the transmitter into master mode.
Select the receiver by pressing the button until the desired receiver con-
firms.
All the following settings will then only be executed for this device.
Press the programming button of the pro-
grammed transmitter.
▻ The receiver makes a "click" sound to
confirm.
► The receiver goes into the programming
mode for 3 minutes
Readying the B-Tronic receiver for program-
ming by switching on the power
Switch on the power.
► The receiver goes into the programming
mode for 3 minutes
11
To Next Page
Loading...
Need help?
General
