Deleting the desired intermediate position
Press the travel button for the desired intermedi-
ate position twice within one second.
▻ The shading solution runs to the inter-
mediate position assigned to the travel
button.
Press the STOP button and, within 3 seconds, also
press the travel button assigned to the intermedi-
ate position and hold the two buttons down.
▻ The tubular drive makes a "click-click"
sound to confirm.
► The intermediate position is now deleted.
Memory function
Every B-Tronic radio receiver for roller shutter and blind installations can save
switching times for UP and DOWN movement.
In the " " operating mode, this movement is repeated every 24 hours.
It does not matter what position the / changeover button is in when pro-
gramming the switching time. Previously stored switching times are overwrit-
ten.
Lights up
green
Roller shutter / all roller shutters are in automatic
mode
Lights up
green
Roller shutter / all roller shutters are in manual
mode
Light up
green
Roller shutters are in different modes
Switching from the " " operating mode to the " " operating
mode must take place via the device on which the automatic
command was programmed. If automatic commands have
been programmed by several devices independently, they
have to be changed to " " separately.
21
To Next Page
Loading...
Need help?
General
