Deleting transmitters
Deleting from B-Tronic receivers with two B-Tronic
transmitters
Put a programmed transmitter, other than the one that is to be de-
leted, into master mode.
Select the device by pressing the button until the desired device confirms.
All the following settings will then only be executed for this device.
While the transmitter is in master mode, the sym-
bols on the changeover button flash green once
per second.
Now press the programming button, until the
status LED changes from green to yellow, and the
receiver confirms.
Changes
from
green to
yellow
Press the programming button, until the status
LED flashes yellow and the receiver confirms.
Flashes
yellow
Now press the programming button of the trans-
mitter to be deleted until the receiver confirms.
► The transmitter is now deleted from the re-
ceiver.
Lights up
green /
red
Action completed successfully (green) or not suc-
cessfully (red).
13
To Next Page
Loading...
Need help?
General
