• Switch off the receiver power for 5 seconds, then switch it back on.
or
• Operate the programming button or the radio switch on the receiver.
The receiver is now in programming mode for 3minutes.
b) Programming transmitters
Please make sure that only one receiver is in programming
mode at any time. It is not possible to program/clear multiple
receivers at the same time.
Press the transmitter's programming button while programming mode is act-
ive, until the receiver confirms successful programming. The status LED
flashes yellow during the programming process.
The programming process is now complete.
Lights up
green /
red
Action completed successfully (green) or not suc-
cessfully (red).
2) Querying the current receiver mode
There are different receiver modes. The receiver mode must always be set ap-
propriately for the receiver (e.g. roller shutter/venetian blind, dimmer/switch).
Roller shutter/venetian blind is the factory setting.
Briefly press the programming button as well as
the changeover button for 1second.
Flashes
yellow
once
Receiver mode roller shutter
Flashes
yellow
twice
Receiver mode dimmer
Flashes
yellow
three
times
Receiver mode switch
9
To Next Page
Loading...
Need help?
General
