Becker centronic sunwindcontrol swc52 - Page 35

fr
en
de
nl
35
Operatingmode
The current wind and/or sunlight settings can be seen in the display.
OKbutton
Press the OK button to store the current values displayed.
To activate the test mode, press the OK button and hold for 5 seconds. In addi-
tion, the MANUAL/AUTO sliding switch must be set to AUTO.
+/-buttons
The following operations are possible using the + and - buttons:
• Menu -> change value
• Auto mode -> request information
• + button -> next automatic switching time s
• - button -> next automatic switching time t
MENUbutton
By pressing the MENU button, you can see an overview of the menu or the op-
erating mode.
The currently displayed values are not stored.
RESETbutton
Press the RESET button (with a ballpoint pen or similar object) to restore the
device’s factory settings (SWC52).
Exception: Function and language selection menu.
Time/datemenu
TIME/DATE
This menu is used to set the time and the date.
Programmenu
PROGRAM
The FUNCTION menu allows you to choose between switching and blocking
times.
These can be set via the PROGRAM menu.
SWITCHINGTIME
Programmable switching times for extension and retraction of awnings.