Becker centronic sunwindcontrol swc52 - Page 36

36
Assembly and Operating Instructions
BLOCKINGTIME
Ensures that your awnings are not extended too early or retracted too late.
E.g.: blocking time t: 9:00
The sun protection system (awning) will not be extended before 9 a.m.
Blocking time s: 16:00
The sun protection system (awning) will be retracted at 4 p.m. even if the sun
is still shining.
Settingsmenu
SETTINGmenu
The following settings can be made via the SETTING menu:
• SUN t (if a sensor is connected)
• DELAY t (only possible if expert mode is activated and a sensor is connect-
ed)
• SUN s (if a sensor is connected)
• DELAY s (only possible if expert mode is activated and a sensor is connect-
ed)
• INTERMEDIATE POSITION
• CANOPY TENSION
• WINTER OFF/ON
• WIND CONTROL
• TIME END LIMIT/INTERMEDIATE POSITION/ CANOPY TENSION (only for
pre-programmed switching or blocking time)
• LIGHT END LIMIT/INTERMEDIATE POSITION/CANOPY TENSION (if a sensor
is connected)
• TEST MODE ON/OFF(if a sensor is connected)
• Language selection (ENGLISH GB)
• SUMMER/WINTER (automatic clock adjustment for daylight saving)
To make settings, press the OK button repeatedly until you reach the menu level
required.
SUNt/SUNs
The threshold value for SUN t is pre-set to 04 and for SUN s to 03.
The value – indicates that the sunshade function has been deactivated. The
brightness value can be set to values ranging between 01 (very overcast) and
15 (direct sunlight).
The existing sunlight setting and the new setting to be made are shown on the
display. The eld for the new sunlight setting ashes.