13
Deleting All the Transmitter Codes Programmed
To delete the hand-held transmitter codes in the radio control receiver proceed as follows:
• Press Program Channel 1 on the radio receiver and keep it pressed. The red signal LED begins to ash slowly. After approx.
5 s the red signal lamp ashes quickly.
• Keep the button pressed until the red signal lamp goes out.
• When the signal lamp goes out, all the codes of the 1-channel radio control receiver and all 4 channels on the 4-channel
radio control receiver will have been deleted.
• Only now let go of the button again.
To Next Page
Loading...
