To Next PageTo Next Page
Need help?Do you have a question about the Beckett AF and is the answer not in the manual?
Defines hazard symbols like Danger, Warning, Caution, and Notice.
Outlines responsibilities for safe burner use and installation.
Warns against modifying the burner's original design and voiding warranties.
Advises against operating beyond specified limits, detailing potential hazards.
Advises on preventing water damage during cold weather operation.
Emphasizes compliance with jurisdictional regulations and handling concealed damage.
Stresses that installation, adjustment, and service require qualified professionals.
Guides on inspecting chimney/vent systems for proper sizing and condition.
Recommends using insulated liners due to potential acid condensation from flue gases.
Details requirements for adequate air supply, including confined spaces and outdoor air kits.
Covers clearances, protecting combustion chambers, and retrofitting dimensions.
Explains the function and importance of the Low Firing Rate Baffle for AFG burners.
Covers verifying fuel unit compatibility and attaching the air tube.
Details correct nozzle selection, pump pressure, and installation procedures.
Provides steps for servicing the nozzle line assembly, including disconnection and removal.
Instructs on checking and adjusting electrode tip settings according to specifications.
Covers bolting the burner using flanges and verifying air tube insertion depth and orientation.
Details how to measure and adjust the 'Z' dimension for F heads to ensure proper combustion.
Explains adjusting the 'Z' dimension for L1/L2 heads based on shroud type and tube length.
Details adjusting the 'Z' dimension for V1 heads and setting head position adjusting plate.
Warns about oil leaks and fire hazards, emphasizing compliance with standards and avoiding Teflon tape.
Covers installation of shutoff valves, filters, and recommended dual filtration systems.
Discusses fuel supply level requirements and the use of by-pass plugs in one-pipe systems.
Warns of electrical shock risk and the need for proper grounding and compliance with codes.
Outlines wiring for packaged and job-site installations, referencing diagrams and codes.
Explains specific wiring requirements for burners with covers, including conduit routing.
Lists key features of the Genisys 7560 control, including thermostat compatibility and delay settings.
Provides guidance on wiring the Genisys 7560 control, emphasizing compliance with appliance and manufacturer instructions.
Briefly describes optional components like Contractor's Tool, Display Module, and Alarm Module.
Details the burner's operating sequence, from standby to recycle and pump prime modes.
Explains the function of the reset button in different burner states, including soft and hard lockout resets.
Describes the meaning of the red, green, and yellow status lights indicating burner operation and fault conditions.
Covers wiring notes and the critical pump priming process to avoid hazards.
Details measuring cad cell resistance and procedures for resetting burner lockouts.
Details essential checks for safe startup, including safe start and flame failure simulations.
Provides steps for adjusting air settings and measuring CO2/O2 for optimal combustion.
Emphasizes the necessity of annual professional service for safety and reliability.
Lists key maintenance tasks like filter replacement, electrode inspection, and cleaning components.
Advises on shutting down the burner for extended periods and turning off electrical power.
Details the procedure for replacing the blower wheel, including gap setting and installation.
Recommends specifying genuine Beckett parts for best performance and lists part numbers for AF burners.
Provides a detailed list of part numbers and their descriptions for burner components.
Outlines warranty terms, qualification requirements, and how to review the policy.
General
