Beckett CG10 User Manual

COMMERCIAL PRODUCTS
Fire, Explosion and Asphyxiation Hazards
Failure to follow these instructions exactly could lead to fi re or explosion and result in
death, severe personal injury or property damage.
Do not store or use gasoline or other fl ammable vapors and liquids in the vicinity of this or any other appliance.
What to do if you smell gas:
- Do not try to light any appliance.
- Do not touch any electrical switch.
- Do not use any phone in your building.
- Immediately call your gas supplier from a telephone outside the building.
- Follow the gas supplier’s instructions.
- Call the fi re department if you cannot contact your supplier.
Installation and service must be performed by a qualifi ed installer, service agency, or the gas supplier.
1.
2.
3.

Beckett CG10 Specifications

General

Model	CG10
Fuel Type	Oil
Frequency	60 Hz
Electrical Rating	120V, 60Hz
Firing Rate Range (GPH)	0.50 - 1.50 GPH
Voltage	120V
Motor HP	1/8 HP

Summary

General Information

Owner's Responsibility

Professional Installer's Responsibility

Outlines the installer's qualifications and compliance requirements.

Pre-installation Checklist

Combustion Air Supply

Ensures adequate air for combustion to prevent performance issues and CO.

Fuel Gas Supply

Ensures compliance with codes and adequate supply for burner operation.

Flue Vent System

Electrical Supply

Mount the Burner & Connect Gas Piping

Connect Gas Piping

Instructions for connecting the gas supply to the burner manifold.

Gas Supply Piping

Guidance on sizing, leak testing, and purging gas supply pipes.

Gas Trains

Information on gas train components, over-pressure protection, and propane conversion.

Wire the Burner

Sequence of Operation & Prepare the Burner for Start-up

Prepare the Burner for Start-up

Steps and considerations before initiating burner startup procedures.

Start-up Checklist

Comprehensive list of checks before attempting burner startup.

Start the Burner

Burner Start Procedure

Step-by-step guide for initiating burner operation and initial testing.

Verify Input Firing Rate

Check Operation and Safety Controls

Verifying the correct function of all operational and safety controls.

Use Test Instruments to Set Combustion

Recommended Combustion Test Sequence

Maintenance and Service

Annual Maintenance

Tasks for qualified technicians to ensure burner performance and longevity.

Adjust the Burner for Proper Combustion

Flame Safeguard

Ignition Reliability

Burner Head Adjustment

Propane Restrictor Description

Installation

Replacement Parts