Parameterization and commissioning
EL6731104 Version: 2.8
Fig.103: Configuration 2
(4) Use the Bus Parameter (DP) button to activate GAP update (multimaster) via the dialog
(5) in order to enable operation of a programming devices at the Profibus for parallel configuration of the
STARTER software
5.1.7.1.2 Configuring fieldbus devices
Append box
In the context menu of the Profibus master card Device1 select "Append Box". Select from folder PROFIdrive
MC (DPV2) (with the respective multiple). Please note that numbers 1-8 are available for selection,
representing up to 6 drive controllers, a CU and an Active Line Module. In the example (sevenfold)
communication via the Profibus takes place in a system of 6 axes and a CU.
To Next Page
Loading...
Need help?
General
