Press and hold and simultaneously, then press and hold the
button on the cord of control box for 3 seconds until your hear 2
beeps sound, the remote is then paired.
Press and hold and simultaneously, then press and hold the
button on the cord of control box for 3 seconds until your hear 2 beeps
sound, the remote is then paired.
For BT1000
For BT2000/BT3000
SETTING PROGRAMMABLE POSITIONS
PAIRING REMOTE
The wireless power bed has a programmable feature that allows you to save custom positions.
Please read all the instructions below before setting your custom presets on the remote.
STEP 1
STEP 2
STEP 3
Adjust the head and foot to your desired position.
To adjust the saved position, repeat steps 1 and 2 and the new
position will be saved.
STEP 1
Make sure the batteries work ne. Replace
them when needed.
The original remote that comes in the box is already paired to the foundation. No further action is required.
In the event that the remote is not paired with the foundation, follow the steps below.
Press and hold the at button rst, then
press and hold memory button for 5
seconds until the buttons' lights are ashing.
The position is then saved.
STEP 3
STEP 2
Plug the power cord to
the power source.
Paring Button
Paring Button
Setting Programmable Positions and Pairing Remote
—11—
Customer Service: 1-855-430-8943
To Next Page
Loading...
