BEECHCRAFT Bonanza Section VIII
V35, V35A & V35B thru 0-9947 Handling, Serv- Maint
If at the end of 30 days airplane will not be removed from
storage, the engine shall be started and run. The preferred
method will be to fly the airplane for 30 minutes, and up to,
but not exceeding normal oil and cylinder temperatures.
PREPARATION FOR SERVICE
Remove all covers and tape, clean the airplane and give it a
thorough inspection, particularly wheel wells, flaps,
control surfaces and all openings.
Preflight the airplane.
EXTERNAL POWER
When using external power, it is very important that the
following precautions be observed:
1. The airplane has a negative ground system. Exercise
care to avoid reversed polarity. Be sure to connect the
positive lead of the external power unit to the positive
terminal of the airplane's external power receptacle
and the negative lead to the negative terminal of the
external power receptacle. A positive voltage must
also be applied to the small guide pin.
2. To prevent arcing, make certain no power is being sup-
plied when the connection is made.
3. Make certain that the battery switch is ON, all avi-
onics and electrical switches OFF, and a battery is in
the system before connecting an external power unit.
This protects the voltage regulators and associated
electrical equipment from voltage transients (power
fluctuations).
January 1982
8-13
To Next Page
Loading...