BeefEater 1500 Series

Questions and Answers

J
James IngramJul 28, 2025
Why BeefEater 1500 will not light?
- H
  Hannah WoodJul 28, 2025
  Your BeefEater Grill might not light due to several reasons. It could be that the ignition system isn't working, so check for a visible spark at the starter probe. Ensure the gas valve on the cylinder is open and that there are no obstructions in the burner ports or gas injectors. Also, make sure the burners are correctly positioned and that the burner ports or throat are not blocked by spider webs or insect nests. If you are turning on the gas control too quickly, allow at least 5 seconds for gas to flow through the burner before ignition. Clean out any blockages as needed.
L
Larry LopezAug 2, 2025
What causes flame separation or noisy burning in a BeefEater Grill?
- D
  David RogersAug 2, 2025
  If the flame appears to separate off the burner or burns with noise in your BeefEater Grill, this may be due to a blockage of burner ports.
C
Cameron AdamsAug 7, 2025
What to do if BeefEater 1500 lights but goes out soon after starting?
- R
  rrodriguezAug 7, 2025
  If your BeefEater Grill lights but then goes out, the issue could stem from the fuel supply. Ensure the gas valve at the cylinder is turned on and that the gas cylinder isn't low or empty; replace it if necessary and perform a leak check. Also, verify that the gas line isn't kinked or twisted, and make sure the grill is shielded from wind or breeze affecting its operation.
T
Tina NavarroAug 12, 2025
Why does my BeefEater 1500 Grill smell like gas?
- R
  Ricky NelsonAug 12, 2025
  A foul smell of gas from your BeefEater Grill could be due to several reasons: a damaged hose, leakage, the burner went off, or incorrect combustion.
R
Robert AvilaAug 17, 2025
Why is there yellow tipping in the flame of my BeefEater 1500?
- A
  Angela FordAug 17, 2025
  Yellow tipping in the flame of your BeefEater Grill may be caused by an incorrect air/gas mixture screw in burner.
A
Amy StoneAug 22, 2025
How to fix burners that will not cross light from one to the other on BeefEater Grill?
- F
  fwalkerAug 22, 2025
  To fix burners that will not cross light from one to the other on your BeefEater Grill, check that the cross light channel is in place and ensure that the burner ports are free of obstructions.