Australia’s Leading Barbecue
10
Beefeater Barbecues
Operating Instructions
Before Lighting
1. Check that all gas hose fittings and connections are
spanner tight. Gas regulators that are fitted with a hand
tightening wheel should be checked to ensure that the
connection is secure.
2. Check that control knobs are in the Off position. Note
that when in the Off position the knob is locked for
safety and can only be operated by pressing before
turning.
3. Open the roasting hood fully or remove the weather
cover/lid from the cooking surface before operating the
barbecue.
4. Clean cooking surfaces thoroughly before use.
5. Check gas supply. Turn on gas supply at either the
cylinder (for Propane / LPG) or shut-off valve (for
Natural Gas).
‘Quartz Start’ Ignition
1. Push in and hold the control knob down while turning
slowly in a counter-clockwise direction until the starter
mechanism engages at the two o’clock position. At this
time the gas will start to flow.
Note: There is a safety lock that prevents the knob from
being turned on accidentally. You must push the knob in
completely to disengage the lock.
2. Hold the control knob in while continuing to turn the
knob to the High or twelve o’clock position.
3. The starter mechanism will click and the main burner
will now light. Continue turning the knob slowly until it is
in the twelve o’clock position.
4. If the burner is alight, release the knob.
Note: If the burner does not light, keep the control knob
pushed in and turn the control knob in a clockwise
direction to return to the Off position. Wait 5 minutes for
the gas to disperse and then repeat steps 1-4.
5. The control knob can now be turned to the desired heat
setting - Low, Medium or High.
The control knob does not need to be pushed in while
selecting the heat setting.
To Turn Off The Burner
Push in and hold the control knob while turning in a
clockwise direction until the Off position is reached.
After Use
1. Be sure to turn off all control knobs and cylinder valve
(for Propane - LPG) or shut-off valve (for Natural Gas).
2. Clean drip tray, griddle plates and grills if necessary.
Allow barbecue to cool before replacing the weather cover/
lid or any polyester barbecue cover.
Lighting Instructions
Press and turn knob slowly to HIGH
If ignition does not occur return
to OFF and repeat after 5 minutes
Low
High
Off
Lighting Instructions
Press and turn knob slowly to HIGH
If ignition does not occur return
to OFF and repeat after 5 minutes
Low
High
Off
Lighting Instructions
Press and turn knob slowly to HIGH
If ignition does not occur return
to OFF and repeat after 5 minutes
Low
High
Off
Lighting Instructions
Press and turn knob slowly to HIGH
If ignition does not occur return
to OFF and repeat after 5 minutes
Low
High
Off
Push in
Hold
Release
Adjust
High - Low
Setting
To Next Page
Need help?
General
