EasyManua.ls Logo

Beem CJ-265 - Page 45

Beem CJ-265
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN 34
5. Regularly run the cleaning programme (see “Self-Cleaning”) to clean the milk tank system as
well as the coffee outlet (14) on the porta lter (12).
6. Wipe down the housing with a damp cloth. If necessary, use a little mild detergent to remove
more intense soiling.
7. Thoroughly dry the device and all accessories before assembling it again.
8. Check the mains cable regularly for any damage.
Self-Cleaning
Quick Clean of the Milk Tank System
The quick clean of the milk tank system should be carried out after every use so that no milk
residues can remain in the system and dry on or go mouldy.
1. Fill the milk tank (9) with water (see the “Handling and Operation” chapter | “Filling the Milk
Tank”).
2. Fold out the milk nozzle (8) using the lever (7) (Picture E).
3. Press the
button (16) to switch on the device and preheat the water. The control panel
ashes during the heating process.
4. Place a suitable cup below the milk nozzle.
5. As soon as the device has heated up, the control panel stops ashing. Press the
button
(20). A beep sounds, the self-cleaning starts and the button ashes.
6. Run the programme and pour away the contents of the cup after the self-cleaning nishes.
7. Repeat this process if necessary.
Intensive Clean of the Porta lter and Milk Tank System
During the intensive clean, the porta lter is also thoroughly rinsed through in addition to the milk
tank system. This allows coffee residues which are stuck on to be rinsed out of the porta lter and
the lters if applicable.
1. Fill the water tank (2) with water (see the “Handling and Operation” chapter | “Filling the Water
Tank”).
2. Also ll the milk tank (9) with water (see the “Handling and Operation” chapter | “Filling the Milk
Tank”).
3. Fold out the milk nozzle (8) using the lever (7) (Picture E).
4. Press the
button (16) to switch on the device and preheat the water. The control panel
ashes during the heating process.
5. Place a suitable cup below the coffee outlet (14) and the milk nozzle.
03428_DE-EN-FR-ES-IT_A5_V4.indb 3403428_DE-EN-FR-ES-IT_A5_V4.indb 34 22.07.2019 10:13:2422.07.2019 10:13:24

Table of Contents

Related product manuals