31 EN
Setting the Quantity of Milk Froth
On the milk tank cover (6) there is a dial (5) which can be used to set whether more milk froth or
more hot milk should be added to the speciality coffee.
For more milk froth: Turn the dial to the top right.
For more hot milk: Turn the dial to the bottom left.
Resetting to Factory Settings
If the quantities of espresso and milk are to be reset to the quantities which are preset at the
factory, proceed as follows:
1. Switch off the device using the button (16).
2. Press the buttons
(24) and (17) simultaneously and keep them pressed.
3. Switch the device back on using the button. The control panel (3) will fl ash fi ve times and
fi ve beeps will be heard.
4. Let go of the
and buttons. The quantities are now reset to the factory settings.
Preparation
NOTICES
• Do not operate the device without water. If this does happen, the device issues an error
message (several beeps in succession) (see the “Troubleshooting” chapter).
• Never use the device without a suitable container below the coffee outlet and the
milk nozzle.
The device remains switched on and the control panel is lit up for up to 30 minutes after
the last action. During this time, the water in the water tank (2) and the cup warmer (15)
are heated. Once the 30 minutes have elapsed, the device switches to stand-by mode and
may need to be switched on again using the
button (16).
If the brewing process is to be aborted prematurely, press the chosen button again. You will
hear a beep, and the control panel is fully lit up again. The device switches to stand-by mode.
Espresso / Double Espresso
The perfect amount of espresso to suit your own taste can be programmed in the device
(see the “Handling and Operation” chapter | “Programming Quantities”)
1. Fill the water tank (1) with water (see the “Handling and Operation” chapter | “Filling the
Water Tank”).
2. Place the fi lter you want
into the portafi lter (12) (see the “Handling and Operation” chapter |
“Inserting / Removing the Filter in the Portafi lter”).
3. Fill the fi lter
with coffee powder (see the “Handling and Operation” chapter | “Filling the Filter
With Coffee Powder”).
03428_DE-EN-FR-ES-IT_A5_V4.indb 3103428_DE-EN-FR-ES-IT_A5_V4.indb 31 22.07.2019 10:13:2322.07.2019 10:13:23
To Next Page
Loading...
