Beem CJ-265 - Milk Froth; Cleaning and Care

33 EN
10. As soon as the device has heated up, the control panel stops fl ashing. Press the button
(23) for cappuccino or the
button (19) for latte macchiato. A beep sounds, the brewing
process starts and the chosen button fl ashes. Milk is heated with steam and frothed up. Hot
water is poured over the coffee powder to brew it.
At the end of the brewing process, a beep sounds, the control panel is fully lit up again and the
device automatically switches to stand-by mode.
Milk Froth
The perfect amount of milk to suit your own taste can be programmed in the device (see
the “Handling and Operation” chapter | “Programming Quantities”)
1. Fill the water tank (2) with water (see the “Handling and Operation” chapter | “Filling the
Water Tank”).
2. Fill the milk tank (9) (see the “Handling and Operation” chapter | “Filling the Milk Tank”).
3. Fold out the milk nozzle (8) using the lever (7) (Picture E).
4. Select the setting you want using the dial for the milk froth (5) (see the “Handling and
Operation” chapter | “Setting the Milk Froth Quantity”).
5. Press the
button (16) to switch on the device and preheat the water. The control panel
fl ashes during the heating process.
6. Place a suitable cup below the milk nozzle.
7. As soon as the device has heated up, the control panel stops fl ashing. Press the button
(21). A beep sounds, the brewing process starts and the chosen button fl ashes. Milk is heated
with steam and frothed up.
At the end of the brewing process, a beep sounds, the control panel is fully lit up again and the
device automatically switches to stand-by mode.
Cleaning and Care
NOTICES
• Do not use any toxic, corrosive or abrasive cleaning agents or scouring sponges to
clean the device. These may damage the surface.
1. Clean the milk tank (9) and the fi lters after every use with mild detergent and warm water or
in the dishwasher.
2. Empty out the drip tray (10) on a regular basis to prevent overfl owing.
3. Rinse through the tube in the milk tank with clear hot water to remove milk residues after
every use.
4. If necessary, clean the water tank (2) and the drip tray (10) and the cover (11) with mild
detergent and warm water or in the dishwasher.
03428_DE-EN-FR-ES-IT_A5_V4.indb 3303428_DE-EN-FR-ES-IT_A5_V4.indb 33 22.07.2019 10:13:2422.07.2019 10:13:24