Your Beeper XRAY XR2 alarm has two protection modes: Full mode (all detections activated) & Eco mode (only the optional functions
are active, the shock sensor is deactivated).
1. Full Mode
To activate the alarm in full mode, press button #3 once. The siren will ring once and the LED lights up for 10 seconds then flashes to
indicate system activation.
In this mode:
• In the event of a slight shock, the siren sounds 5 times then stops (= first level of the shock sensor).
• In the event of a major shock, the siren sounds for 30 seconds then stops (= second level of the shock sensor).
• If multiple light shocks are detected within 10 seconds, the siren sounds for 30 seconds and then stops.
• If the optional functions trigger the alarm (eg door opening, ignition, etc.), the siren sounds continuously.
To deactivate the alarm, press button #1 once. The siren rings twice and the LED goes out.
2. Eco mode
To activate the alarm in eco mode, press button #3 once. The siren will ring once. Press button #3 again.
The siren beeps again and the LED starts flashing to inform you that the eco mode is activated.
/!\ Important /!\
In this mode, the shock sensor is disabled. Only optional functions can trigger the alarm. If no optional function connected (WHITE,
ORANGE & BLUE cables), no active detection.
To deactivate the alarm, press button #1 once. The siren rings twice and the LED goes out.
3. Vehicle detection function / Panic mode
To detect the vehicle (or panic mode), it is necessary to perform 3 consecutive slow presses on button #3 .
USING THE ALARM
17
To Next Page
Loading...