4. Emergency deactivation
Note: Requires the connection of the white wire (+12V APC) and the blue wire (perimetry).
Open a door (if perimeter connected) or ground the BLUE wire.
Switch the ignition from ACC ON to ACC OFF 5 times, then stay in the ON position. The siren beeps 3 times to indicate deactivation.
5. Shock Sensor Sensitivity Adjustment
The sensitivity of the shock sensor can be adjusted in 5 levels. 1 = Shock sensor disabled, 5 = Maximum sensitivity. By default, the
shock sensor is set to level 3.
To adjust the sensitivity of the shock sensor, press button #3 for 2 seconds. The siren will beep 5 times to indicate you have entered
programming mode.
• To lower the sensitivity of the sensor, press button #3 as many times as desired.
• To increase sensor sensitivity, press button #1 as many times as desired.
To exit settings mode, do not touch the remote control for 10 seconds. The siren beeps 3 times to indicate exit from programming mode.
6. Activation/Deactivation of the current consumption sensor
To access the current consumption sensor settings, press button #1 for 2 seconds. The siren will beep 3 times to indicate you have
entered programming mode.
• To activate the current consumption sensor, press button #3 once. The siren then beeps once in response.
• To deactivate the current consumption sensor, press button #1 once. The siren then beeps twice in response.
To exit settings mode, do not touch the remote control for 10 seconds. The siren beeps twice to indicate exit from programming mode.
18
USING THE ALARM
To Next Page
Loading...