Bego Fornax T User Manual

English ⋅ Fornax
®
T
21
86107 BA-en/01
en
Insert mould
1. Insert the preheated mould into the mould
holder. The mouth of the ingot mould must
face the crucible.
2. Lower the crucible coil to adjust the mould dis-
tance. Push the handle located on the right
exterior side of the device backward for this
purpose.
3. Oval moulds (see image) may be inserted as
well. For this purpose, the angle of the crucible
holder can be adjusted individually by loosen-
ing and/or tightening the mounting screws.
WARNING
Burn hazard from hot parts!
• Always use mould tongs to move
moulds.
• Wear suitable protective equipment
when operating the device!
CAUTION
Mould temperatures above
1050°C may cause the device to
overheat.
Never use damaged or cracked
moulds.
NOTICE
Ideally, the setup should be carried out with a cold
mould before it is placed into the preheating
oven. A "dummy" may be used alternatively.
A setup with a hot mould is required if the
presetting did not take place or if the model
casting moulds have different shapes, for
instance if they are imbedded with crepe sleeves.
(here, moulds may have different heights and
diameters)

Bego Fornax T Specifications

General

Brand	Bego
Model	Fornax T
Category	Dental equipment
Language	English