English
⋅
Fornax
®
T
23
86107 BA-en/01
7. Move the slider towards the mould by its han-
dle (4).
.
8. Lock the slider. Turn the clamping lever (5)
clockwise for this purpose. The slider can now
only be moved to this point.
ATTENTION!
• The ceramic crucible may get damaged if the
slide is not moved back smoothly!
• The slider is properly positioned when the cru-
cible pouring spout reaches into casting funnel
of the mould.
• A gap (approx. 1-3 mm) remains between the
edge of the mould and the slider to avoid any
damage on the mould as well as defective cast-
ings.
The clamping lever must point towards the
crucible when it is locked!
To Next Page
Loading...
