English ⋅ Nautilus
®
CC plus ⋅ Nautilus
®
T
17
86105 BA-en/00
Electricity
Prior to connecting the device to the power supply,
check and make sure that the specifications on the
rating plate correspond to the power supply
network. Consult an electrician in case of uncer-
tainty.
The device is subject to protection class I and must
only be connected to properly grounded and fused
power sources.
Recommendation: Always operate the device in a
single power circuit (min. 16A fuse).
Installation in countries without 230 V network:
The electrical installation must only be carried out by
a qualified electrician!
Use the transformer (REF 17800) for connection.
1. Adapt the power connection of the transformer
to local circumstances.
2. Insert the Nautilus
®
-power plug into the trans-
former.
The device is subject to the provisions of class of
protection I and may only be connected to properly
grounded power sources.
Pyrometer
Remove the cover of the precision optics before
initial commissioning (NAUTILUS
®
CC plus only)
To Next Page
Loading...
