EasyManua.ls Logo

Bego Nautilus CC plus - Installation Procedures; Cooling Water and Compressed Air Setup

Bego Nautilus CC plus
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16
86105 BA-en/00
English Nautilus
®
CC plus Nautilus
®
T
en
Installation
Cooling water
Adding cooling water (see page 72).
Compressed air
1/4 "
5 .... 8 bar (0.5 .... 0.8 MPa) (72.5 .... 116 psi)
100 l / min
Insufficient supply of compressed air during
pressure casting (warning message W011) can be
compensated with the compressed air reservoir
(REF 16260).
Insufficient supply of compressed air during evacu-
ation (warning message W002, W013) cannot be
compensated with the compressed air reservoir.
Important! Remove protective cap!
WARNING
The warning signs provided (symbol:
"pacemaker") are to be placed at the
entrances to the room in which the
ready-to-use device is located!
NOTICE
After initial commissioning, run the device for at
least 2 minutes to allow for the cooling water to
circulate and check the water level again.

Other manuals for Bego Nautilus CC plus

Related product manuals