Bego Nautilus CC plus User Manual

English ⋅ Nautilus
®
CC plus ⋅ Nautilus
®
T
33
86105 BA-en/00
en
Deleting non-BEGO alloys programs
1. Press the "New/Delete" button.
2. Select the alloy to be deleted-
3. Press "Delete".
Explanation of the foot notes on page 34:
LFC = Low Fusing Ceramic
✔ /- = yes/no
* Symbol for "bonding"
1 A glassy carbon insert may be used instead of
a graphite insert (see page 28).
2 Only use BEGO Auromelt HF as melting
powder. Melting powder from other manufac-
turers may impair the casting result. If no
melting powder is used, large alloy residues
remain inside the crucible and the casting result
may be impaired. Use Auromelt HF very
sparingly (only a pinch)!
3 The higher the scrap metal content and/or the
lower the modulation thickness, the higher the
preheat temperature should be.
4 Use the glassy carbon insert if the alloy chips
rise and do not "mix".
5 Use programs 181 to 186 if the alloys tend to
splatter when heated under vacuum.
NOTICE
• Only non-BEGO alloys can be deleted.
• If no new program has been set up so far, the
button will only read "New"

Bego Nautilus CC plus Specifications

General

Brand	Bego
Model	Nautilus CC plus
Category	Dental equipment
Language	English