Replace the air filter
A dirty air filter can be recognized by the fact that the
pressure values are no longer attained during
preheating and melting.
1. Switch off the machine and pull out the mains
plug.
2. Remove the panel (1) on the left side (loosen
knurled screws).
3. Replace the dirty air filter (2).
Reactivate fuses
There are automatic circuit-breakers against
overcurrent (see circuit diagram) on the rear panel
of the machine.
1. Switch on fuses that are switched off by press-
ing them in again. (After they have switched
off, wait for approx. 1 minute.)
2. If fuses are triggered repeatedly, notify Cus-
tomer Service.
Request transport packaging
1. In the case of servicing, transport packaging
should be requested from BEGO for safe
transport.
+49 421 2028-274
REF 16 287
2. See page 6 for correct packing of the machine.
To Next Page
Loading...
