Bego Nautilus T Translation Of The Original Instructions

48
86066 BA-en/00 357.00001.../ 358.00001...
English ⋅ Nautilus
®
CC plus ⋅ Nautilus
®
T
en
Clean ejector
In the event of the message W 13, the so-called
ejector must be cleaned.
1. Switch off the machine and pull out the mains
plug.
2. Remove the panel (1) on the left side (loosen
knurled screws).
3. Screw out silencer (2) and ejector.
4. Clean the ejector by means of blasting.
5. The nozzle in the ejector must not be shifted. It
must project by 8 mm (see A).
CAUTION
Only use blast polishing material that
does not remove any ejector material
(recommended: BEGO Perlablast).

Bego Nautilus T Specifications

General

Brand	Bego
Model	Nautilus T
Category	Dental equipment
Language	English