Safety instructions
The 3D print system BEGO VARSEO S is based on
DLP technology (Digital Light Processing); it is
intended solely for dental applications to create
objects from stereo lithography resins, which have
been approved by BEGO. Any other use is
considered to be improper. We shall not be liable for
any damage resulting from improper use.
The safety instructions must be followed in order to
prevent personal injury and damage to the machine.
We shall not be liable for damage due to failure to
comply with the safety instructions.
General safety instructions
Place where effective - The device has been
designed solely for use in dental laboratories and
comparable establishments for research,
commercial and training purposes.
The device may only be installed on a sufficiently
stable surface. The height of the table should not
exceed 720 mm to avoid posture problems.
The device should only be used in dry, dust free
and well ventilated rooms.
Operator and operating personnel - The
device must only be operated by dental profes-
sionals; trainees and other persons operating the
device must be supervised.
Wear the protective clothing prescribed for use in
dental laboratories and observe the rules of
conduct.
The device may only be operated by staff members
who are familiar with and follow the instructions of
this operating manual.
The operating manual must be easily accessible
when the machine is operated. Observe the national
accident prevention regulations in addition to this
operating manual.
Handling the machine - Check if the specifica-
tions on the type plate correspond to the power
supply network before connecting the device.
Consult an electrician in case of uncertainty.
The device is categorised under protection class I
and may only be connected to properly earthed
power sources (earth contact sockets).
Modifications of the machine are not permitted.
Always keep signs and stickers such that they are
easy to read. They must not be removed.
Check the machine and leads for damage regularly.
The machine must not be operated if it has any
defects that may result in risks for the employees or
third persons.
The operation of the device requires a LAN or
WLAN connection, which must be set up
beforehand!
Protect the leads against heat, oil and sharp edges.
The leads must not be used to carry the machine or
to pull out the mains plug.
Repair work - Repairs may be carried out solely
by BEGO customer service personnel or by persons
authorized by the BEGO customer service
department.
Metallic housings must be grounded properly so
as to prevent them from carrying current. Otherwise
they are extremely dangerous because the
housings may be live due to damage to the
machine! Since a check to ensure a de-energized
state is mandatory after every intervention in the
machine (Germany: check in accordance with DIN
VDE 0701-1), only qualified electricians may open
the machine!
Only BEGO replacement and wearing parts may be
used.
Care and maintenance - Switch off the machine
and pull out the mains plug before performing any
care, cleaning or maintenance work.
Only use dry or slightly moist cloths for cleaning. Do
not spray the machine with water or immerse it in
water.
To Next Page
Loading...
Need help?
General
