VARSEO S cartridge
1 Star knob
2 Lift rod
3 Detent pin
4 Cover, VARSEO S cartridge
5 Bayonet coupling
6 VARSEO S cartridge
7 Cartridge label
8 Base plate with handle
9 Stamp with resin receptor
10 O-seal
11 Non-stick film
12 Borosilicate glass plate
13 Protective ring
14 Screws
15 Space for RFID chip
The resin mixture needed for a print job is filled into
the VARSEO S cartridge.
An RFID chip (adhesive label) is affixed to the resin
package; this label must be placed on the desig-
nated space on the VARSEO S cartridge. It serves
to identify the resin; every time a new resin package
is opened.
Pay attention to the proper allocation of the
VARSEO S cartridge A/B: VARSEO S cartridge B
for surgical guide clear, model, temp and VARSEO
S cartridge A for CAD/CAST, tray, surgical guide,
dent, splint.
A sealing ring, a non-stick film, a glass plate and a
protective ring are located in the bottom area. These
can be replaced whenever necessary (→ page 36 -
40).
Stamp with resin receptor - The finished object
remains on the stamp after the print job has been
completed. A spatula facilitates an easy and clean
removal of the print job from the stamp.
To Next Page
Loading...
