Switch-on and loading print objects
1. Switch on the device.
The device performs a reference run.
After 2-3 minutes the unit is ready for opera-
tion.
The menu box opens (→ illustrations).
2. Send the print job to the printer, either via the
supplies USB flash drive, with CAMbridge via
the network or via the VARSEO S Service
Board (for further information, please refer to
chapter "Operation via Web Interface", page
33).
As long as no USB flash drive is plugged into
the port or if the file cannot be found via the
network, the menu box will be indicating that
the system is searching for a file .
3. Press the "Print" button and select a job file.
The VARSEO S cartridge must not be inside of
the device during a reference run. The cover
must be closed and all the levers open.
Please note, that the VARSEO S printer must be
online and registered on www.my.BEGO.com to
execute print jobs!
Setup see page 16 ff.
To Next Page
Loading...