English VARSEO S
29
86087 BA-en/02
Print
1. Open the cover after the reference run.
2. Push the VARSEO S cartridge against the fas-
teners using the front handle (1), then push
down both of the bottom levers (2) and finally
secure the upper lever (3).
3. Close the cover, select the print job and press
the "Print" button. The job is executed.
Display screen → page 27
At any point in time the display shows the current
layer being printed.
Crushing hazard
There is a risk of crushing when
installing the VARSEO S cartridge
and closing the cover.
Be careful with your fingers.
Property damage
• The lift rod must be clamped near the milled
recess (→ Illustration below). Otherwise, an
error message is issued.
• All screws of the lower lever (2) and the upper
lever (3) must facilitate that the cartridge is firm-
ly fastened. Otherwise, retighten them or con-
tact the service department.
Abort Job
Press "Print" > "Abort print" and confirm the
prompt if you need to abort a job while it is being
printed,
To Next Page
Loading...