Removing the print job from the bottom platform
1. Place the VARSEO S cartridge on free area.
Make sure that the lift rod of the stamp is prop-
erly latched on the cover. Rotate the lift rod to
remove any remaining resin from the object.
2. Release the bayonet coupling and remove the
cover of the VARSEO S cartridge.
The ejection device into which the stamp is
clamped horizontally (→ Accessories).
3. Carefully remove the object from the stamp
using the spatula (→ Scope of delivery). Place
the spatula on the grooves and holes of the
stamp plate first.
Risk of injury
• Any resin that has accidentally be
spilled on the floor must be wiped
and cleaned with ethanol and paper
towels to prevent any slip hazard.
To Next Page
Loading...