Bego VARSEO S Basic User Manual

42
86087 BA-en/02
English VARSEO S
en
The print job has been
exposed for an incorrect
amount of time.
If a job was completed with errors or if the object does not stick to the stamp,
the exposure time may have been incorrect. In this case do not switch off the
printer and do not remove the USB flash-drive from the device. Contact the
service department which will check the protocol on the flash-drive.
Errors without error
message
Remedy

Bego VARSEO S Basic Specifications

General

Brand	Bego
Model	VARSEO S Basic
Category	3D Printers
Language	English