Behncke QWT - Installation Layout below the Water Level; Connecting the Heat Exchanger

Water/water heat exchanger – QWT, WTI, SWT, SWT-T
01.07.2015
16
Setup/installation
3.4.2 Installation layout below the water level
3.4.3 Connecting the heat exchanger
CAUTION!
Install the stop and drainage valves in the feed and return lines of the heating
circuit inside the frost-proof area of the building.
The heat exchanger may be damaged.
Ensure that the water quality and maximum pressure levels are observed.
CAUTION!
The heat exchanger may be damaged.
When installing a third-party circuit, make sure that metal parts cannot enter
the heat exchanger.
The heat exchanger and steel pipes are electrically isolated by brass
connections.
The heat exchanger can be damaged by chemicals.