Water/water heat exchanger – QWT, WTI, SWT, SWT-T
01.07.2015
9
Safety
1.5 Safety precautions at the installation site
The heat exchanger must be fitted in a frost-free area using the bracket supplied.
Make sure that the maximum positive operating pressure of 300 kPa (3 bar) on the secondary
side and 1000 kPa (10 bar) on the primary side is not exceeded.
The heat exchanger or surroundings may be damaged.
Inspect the heat exchanger and its connections for leakage and external
damage at least once a week during pool operation.
To Next Page
Loading...
