Page 2 of 6
Independent DC and thermal
overload protection on each channel
automatically protects ampli er and
speakers without shutting down
the show
“Back-to-front” ventilation system
including air lter for
reliable operation
NU6000DSP — Ultra-Lightweight,
High-Density 6000-Watt Power
Ampli er with DSP Control and
USB Interface
Delivers 2 x 3000 Watts into 4 Ohms,
2 x 1500 Watts into 8 Ohms and
weighs less than 12 lbs.
NU3000DSP — Ultra-Lightweight,
High-Density 3000-Watt Power
Ampli er with DSP Control and
USB Interface
Delivers 2 x 1500 Watts into 2 Ohms,
2 x 880 Watts into 4 Ohms,
3000 Watts into 4 Ohms bridged
and weighs less than 8 lbs.
NU1000DSP — Ultra-Lightweight,
High-Density 1000-Watt Power
Ampli er with DSP Control and
USB Interface
Delivers 2 x 500 Watts into 2 Ohms,
2 x 300 Watts into 4 Ohms,
1000 Watts into 4 Ohms bridged
and weighs less than 8 lbs.
Common Features:
Ultimate reliability through
revolutionary cool-running
High-Density Class-D technology
with "near-zero" thermal buildup
Ultra-e cient switch-mode power
supply for noise-free audio,
superior transient response and
low power consumption
Front Panel
iNUKE NU6000/NU3000/NU1000
The rear panel is just as elegant,
with combo XLR and ¼ " TRS input
connectors making the iNUKE compatible
with virtually any source, balanced or
unbalanced. Professional twist-lock
speaker sockets are provided to ensure
every drop of output power gets to
your loudspeakers. The rear panel is
also where you’ll nd the switches that
enable iNUKE amps to work in either
dual mono, stereo or mono bridge
mode. A built-in CROSSOVER switch
enables the amp to operate in biamp
mode, sending low frequency content
to passive subwoofers, while the high
frequency output is channeled to
fullrange loudspeakers (CH1>100 Hz /
CH2<100 Hz or FULLRANGE). Flick the
LIMITER ON/OFF switch to activate the
built-in overload protection, or turn it o
if you’re feeling lucky.
iNUKE DSP
For sound engineers requiring
high-level control capability, iNUKE DSP
Series ampli ers come ready for action
right out-of-the-box. The built-in DSP
and 24-bit/96 kHz converters ensure the
ultimate signal integrity with an extremely
broad dynamic range. DSP functions
include a sophisticated delay for
delay-line loudspeakers, crossover,
EQ (eight parametric, two dynamic),
and dynamics processing with lockable
security settings. A convenient front
panel LCD display allows you to setup
and make adjustments directly at the
ampli er, without the need for a PC.
All iNUKE DSP models can be set up,
controlled and monitored via the front
panel USB connector.
Continued on next page
GAIN
CONTROLS
adjust
input level
Power
button
TWIST-LOCKING
SPEAKER
OUTPUTS
accept
professional
speaker cables
Power
Connection
INPUTS connect
sound source
using ¼" TRS
/ XLR combo
jacks
MODE switches
selects dual-
mono, stereo or
bridged mono
operating modes
Rear Panel
iNUKE NU6000
NU3000
NU1000
NU6000DSP
NU3000DSP
NU1000DSP
To Next Page
Loading...
Need help?
General