Behringer NEUTRON - Neutron Overview and Setup; Connection and Software Setup; Hardware Setup and Oscillator;Filter Details

16. ATT1 CV – Attenuator 1 CV.
17. ATT2 IN – Attenuator 2 signal input.
18. SLEW IN – Slew signal input.
19. SUM1(A) – SUM 1 first signal input. See 98.
20. SUM1(B) – SUM1 Second signal input. See 98.
21. SUM2(A) – SUM 2 first signal input. See 99.
22. SUM2(B) – SUM 2 first signal input. See 99.
OUTPUT PATCH BAY SECTION
23. OSC 1 – Output of Oscillator 1.
24. OSC 2 – Output of Oscillator 2.
25. OSC Mix – Output of OSC 1/2 mix.
26. VCF 1 – Main output of the filter.
27. VCF 2 – Alternate output of the filter.
28. OVERDRIVE – Overdrive output signal.
29. VCA – Voltage Controlled Amplifier output signal.
30. OUTPUT – Main output signal, post delay.
31. NOISE – Output of the white noise generator.
32. ENV1 – Envelope 1 output.
33. ENV2 – Envelope 2 output.
34. INVERT – Inverted version of signal applied to INVERT IN. See 48.
35. LFO – Output of the Bipolar LFO (-5 V to +5 V).
36. LFO UNI – Output of the Unipolar LFO (0V to +5 V).
37. S&H – Sample and Hold output signal.
38. MULT 1 – Duplicate of signal applied to MULT IN. See 68.
39. MULT 2 – Duplicate of signal applied to MULT IN. See 68.
40. MIDI GATE – MIDI gate output.
41. ATT1 – Output of Attenuator 1.
42. ATT2 – Output of Attenuator 2.
43. SLEW – Output of Slew.
44. SUM1 – Summation of SUM 1(A+B).
45. SUM2 – Summation of SUM 2(A+B).
46. ASSIGN – Assignable output. See User Configurable Options & Features.
Step 2: Controls
REAR PANEL
47. INPUT – External audio is injected into the VCF.
48. OUTPUT – Connect to a mixer or audio interface using ¼” Jack cable.
49. PHONES – Headphones output.
50. PHONES LEVEL – Headphones level control.
51. MIDI CHANNEL SELECTION.
Move the four dip switches to select the MIDI channel.
52. MIDI THRU – Soft MIDI THRU.
53. USB PORT – Capable of sending and receiving MIDI information over USB.
54. POWER SWITCH – Turns the synthesizer on and off.
55. POWER INPUT – Connect the supplied power supply only.