Behringer RD-9 - MAP; PREFS

17 RHYTHM DESIGNER RD-9 User Manual
This function allows communication with various analogue clock types
as listed below:
11.4 MAP
The map function allows you to change the MIDI notes that trigger the RD-9
voices either via the USB or MIDI ports.
The default numbers are listed in the table below.
To enter the MAP settings page press SETTINGS, select MAP (STEP BUTTON 4) and
use the SELECT key for each voice to view the current MIDI note number. The DATA
knob can be used to adjust the number from 0-127.
The MIDI map is set globally and is the same for all songs and patterns.
11. 5 PREFS
To enter the PREFS settings page press SETTINGS, select PREFS (Step key 6) and
use the DATA knob to adjust the various settings.
Enhanced Mode
This mode, when turned on activates the extra controls for the Bass Drum
(P.DEPTH and PITCH) and the Hi-Hat pitch.
To turn Enhanced Mode on:
1. Enter the PREFS settings.
2. Find Enhanced Mode by pressing the TAP/HOLD button.
3. Use the DATA control to turn on.
4. Press settings twice to exit.
Chain Songs
The Chain function allows you to link together songs. PREFS has three options:
• • Loop – Causes selected song to loop from beginning to end until the
STOP button is pressed. Pressing the PLAY/PAUSE button will cause the
next selected song to start from the beginning.
• • Hold – Causes the last bar of the selected song to repeat until stop is
pressed. Pressing the PLAY/PAUSE button will cause the next selected
song to start from the beginning.
• • Stop – The selected song will run from beginning to end, then stop at
the end of the last bar. Pressing the PLAY/PAUSE will cause the next
selected song to start from the beginning.
Note that the above preferences are over-ridden when chaining songs
(see section 8).
Filter HPF Preference
Set the HPF on/o state Globally, by Song or by Pattern.
Filter Io Preference
Set the Filters on/o state Globally, by Song or by Pattern.
Filter Auto Preference
Set the lters Automation state Globally, by Song or by Pattern. This determines
how the lter uses recorded lter automation information.
Poly Preference
Set the Poly loop function to be controlled Globally, by Song or by Pattern (See
section 11.7 for more information on polyrhythms).
Step Size Preference
Set the Step Size to be controlled Globally, by Song or by Pattern.
Auto Advance Preference
Set the Auto Advance Globally or by Song.
Auto Scroll Preference
Set the AUTO SCROLL function Globally or by Pattern.
Bus Send Preference
Set the bus send to Filter and Wave Designer Globally, by Song or by Pattern.
Mute Preference
Set the mute control preference Globally, by Song or by Pattern.
Solo Preference
Set the solo control preference Globally, by Song or by Pattern.
Accent Preference
Set the accent control preference Globally, by Song or by Pattern.
Clock Settings
1 PPS
1 PPQ
2 PPQ
4 PPQ
24 PPQ
48 PPQ
Voice MIDI Note No.
Bass Drum 36
Snare Drum 40
Low Tom/Low Conga 45
Mid Tom/Mid Conga 47
Hi Tom/Hi Conga 50
Rim Shot/Claves 37
Clap/Maracas 39
Cowbell 56
Cymbal 51
Open Hat 46
Closed Hat 42