Behringer RD-9 - Page 25

25 RHYTHM DESIGNER RD-9 User Manual
Song Parameters
Some of the parameters in the Song Data le are comparable to the Global Parameters. When these parameters are in use (i.e. the corresponding Preference is set to
Song), loading a new song will trigger the corresponding change in the sequencer. A tempo change is one such example.
Preference Name Description Values
Tempo The tempo of the song is stored. 20 – 240 BPM
Swing The Swing level is stored. 50 – 75 %
Probability The probability of a step being heard is stored per song. 0 – 100 %
Flam The am level is stored per song 0 - 24
Filter Mode Filter Mode is stored per song, either LPF or HPF. 0 = LPF,
1 = HPF
Filter Enable Whether the lter is on/o per song. 0 = O,
1 = On
Filter Automation Automation of the lter is stored per song. 0 = Inactive,
1 = Active
Filter Step Values
(1 - 64)
Filter step values per song are stored. 0 – 255
Polymeter Polymeter is either on/o per song. 0 = O,
1 = On
Step Size Step size is stored for the song. 0 = 1/8
th
,
1 = 1/8
th
Tr,
2 = 1/16
th
,
3 = 1/16
th
Tr,
4 = 1/32
nd
th
Auto Advance Whether or not the song will auto advance to the next or not is stored per song. 0 = O,
1 = On
FX Bus Sends Whether or not the FX bus send is active or not, stored per song. 0 = Inactive,
1 = Active
Mute Voices Which voices are muted, stored by song. 0 = Inactive,
1 = Active
Solo Voices Which voices are soloed, stored by song. 0 = Inactive,
1 = Active
Accent Mode Accent Mode is stored per song. 0 = Global,
1 = Independent
Accent Values (1 - 10) Accent Values are stored per song. Global Accent Values
(1 - 10)