Behringer Ultralink Pro MX882 - INTRODUCTION

12 ULTRALINK PRO MX882 Quick Start Guide 13
ULTRALINK PRO MX882 Controls
(EN) Controls
(11)(12)(10) (14)
(16)
(15) (13)
(1)
(2)
(3) (6)(4) (7) (9)
(5) (8)
(1) The MAIN INPUT LEVEL control sets the main
input gain, before the signal reaches the input
bus. In SPLIT mode, the MAIN INPUT LEVEL
control determines the common output level
for all mono outputs.
(2) The 4-digit INPUT LEVEL meter informs you
about theinput level of the main input within
a range from -24 to +6 dB.
(3) By depressing the MAIN LINK switch you can
route the MAIN INPUT signal to the MAIN OUT.
(4) The MAIN OUTPUT LEVEL control adjusts
the output level applied to the main outputs.
The levels present at the six mono outputs are
not aected.
(5) The 4-digit OUTPUT LEVEL meter informs
you about the output level of the main input
within a range from -24 to +6 dB.
(6) This SPLIT/MIX switch sets the respective
channel to SPLITTER or MIXERmode.
(7) The LEVEL control determines the signal level
of the individual channels. InSPLIT mode,
the LEVEL control sets the output level of the
mono channels. In MIX mode, however, it
controls the amount of the mono channel’s
input signal feeding into the main output
section; atthe same time, the level of the
mono channel can be determined, which—
owing to the maximum gain of +15 dB—
allows for converting, e.g., home recording
levels (-10 dBV) intostudio levels (+4 dBu).
(8) The 8-digit OUTPUT LEVEL meter informs you
about the output level of each channel within
a range from -24to +18 dB.
(9) With the BALANCE/PAN control you can set
the balance between the left and right main
signals. InSPLIT mode, the main input signal is
routed to the mono output, withthe BALANCE
control determining the balance beween the
left and right main signal portions. In MIX
mode, the mono inputs are mixed and routed
via the LEVEL control to the main outputs,
withthe PAN controls determining the
allocation of the mono inputs to the left and
right main outputs.
(10) MAINS CONNECTION.
(11) MAIN INPUTS. These are the main audio
inputs of your ULTRALINK PRO, available as
balanced XLR connectors. They may feed
the mono outputs of all channels which are
operated in SPLIT mode.
(12) MAIN OUTPUTS. These are the main outputs,
availableas balanced XLR connectors. They
may be fed either by the left and right main
inputs or by any of the six mono inputs (or a
combination of both).
(13) MONO INPUTS (channel 1 to 4). These are
the monoinputs. Connectiontakes place via
balanced XLRconnectors.
(14) MONO OUTPUTS (channel 1 to 4). These are
the mono outputs, available as balanced
XLR connectors.
(15) MONO INPUTS (channel 5 to 6). These are
the mono inputs. Connectiontakes place via
balanced phonejacks.
(16) MONO OUTPUTS (channel 5 to 6). These are
the mono outputs, available as balanced
phone jacks.