Behringer Xenyx UFX1604 User Manual

24 XENYX UFX1604 Quick Start Guide 25
Recording to USB drive in STAND-ALONE mode
(EN) Step 7: Recording
to USB drive in
STAND-ALONE
mode
Transport Control Feature Chart
Show Remaining Time
Press TIME REMAIN short
Show Sampling Rate
Push and hold TIME REMAIN button until the
sample rate is displayed
Select Sampling Rate 44.1 kHz
Push and hold TIME REMAIN until the
sample rate appears and then press while still
holding TIME REMAIN
Select Sampling Rate 48 kHz
Push TIME REMAIN until the sample rate
appears and then press while still holding
TIME REMAIN
Toggle PLAY<>PAUSE
Press PLAY (to start) > press PLAY (to pause)
>press PLAY (to continue) > etc.
Toggle Recording Mode (e.g. “001”) <>
Playlist Mode (e.g. “P01”)
Push TIME REMAIN + for two seconds
Toggle Single Playback (“Pxx”) <>
Continuous (“cxx”) Playlist [only in Playlist Mode]
Push PLAY for two seconds
FAT-formatting the USB drive*
Press together STOP + for two seconds
Delete current song (in Recording Mode)*
Press together PLAY + for two seconds
*press PLAY to confirm / any other button to abort
Error Codes:
DrP
Dropout while recording. A summary of the total
number of dropouts will be displayed after recording
(e.g. d03).
FSE
File system error. Incompatible le system on the drive.
Drive must be formatted by the UFX.
oFF
Recorder switches o if a drive has been specied as
SLO (too slow).
SLO
The connected USB drive has been specied as
too slow. No recording will be possible.
Although USB sticks and 2.5" USB-powered external drives could work, the use of powered hard drives for direct recording with the internal USB
recorder is recommended.
The TRANSPORT CONTROL section on the UFX1604
can operate as a MIDI controller in one of two modes:
STANDARD MIDI MODE or MACKIE CONTROLMODE.
The Mixer must be turned o.
To select MACKIE CONTROL MODE,
hold , turnthe power on and then
release when “MAC” shows up in
the display. To select STANDARD MIDI MODE,
Hold , turn the power on, then release
when “STD” shows up in the display.
For STANDARD MIDI MODE, map the
transport controls in your recording
software to the TRANSPORT CONTROL
buttons on the UFX1604. In MACKIE CONTROL MODE,
set your recording software to follow the
appropriate protocol.
For further information, see the full manual at
behringer.com.
Using the MIDI CONTROL Features
(EN) Step 8: Using the
MIDI CONTROL
Features

Behringer Xenyx UFX1604 Specifications

General

Brand	Behringer
Model	Xenyx UFX1604
Category	Music Mixer
Language	English