EasyManuals Logo

Beijer Electronics X2 base 7 v2 HP Hardware And Installation Manual

Beijer Electronics X2 base 7 v2 HP
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
Separate the high voltage, signal, and supply cables.
Make sure that the voltage and polarity of the power source is correct before connecting the HMI
panel to the power outlet.
Peripheral equipment must be appropriate for the application and location.
1.6. During Use
Keep the HMI panel clean.
Emergency stop and other safety functions may not be controlled from the HMI panel.
Do not use excessive force or sharp objects when operating the touch screen.
1.7. Service and Maintenance
Only qualified personnel should carry out repairs.
The agreed warranty applies.
Before carrying out any cleaning or maintenance operations, disconnect the equipment from the
electrical supply.
Clean the display and surrounding front cover with a soft cloth and mild detergent.
The battery must be replaced by an authorized Beijer Electronics service center.
1.7.1. Cleaning the Display
We recommend using a dry, clean cloth to wipe off dust regularly. Use alcohol or ammonia-based
cleaning agent for cleaning only when necessary. When other solvents or cleaning agents are used,
be sure to follow manufacturers’ instructions. The agent should be applied to a clean cloth and
should not be sprayed directly onto the panel surface. After cleaning the agent should be removed.
Ammonia-based glass cleaners (typically 5-10% ammonia) or 75% alcohol can be used to clean the
surface of PCAP and resistive touch panels. When you clean the surface of your touch panel, please
follow these steps:
1. Apply cleaning agent (alcohol, bleach, or glass cleaner) to a clean cloth.
Make sure the cloth is well saturated.
2. Wipe the touch panel surface in a “Z” motion (see illustration below).
3. Dry the panel thoroughly with a dry cloth, removing as much of the cleaning solution as possible.
4. Do not mix bleach and ammonia because this will produce a dangerous chemical reaction.
5. Please do not spray cleaning solution directly onto the touch panel surface.
Safety Precautions
Beijer Electronics, MAEN330 7 2023-09

Other manuals for Beijer Electronics X2 base 7 v2 HP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Beijer Electronics X2 base 7 v2 HP and is the answer not in the manual?

Beijer Electronics X2 base 7 v2 HP Specifications

General IconGeneral
BrandBeijer Electronics
ModelX2 base 7 v2 HP
CategoryTouchscreen
LanguageEnglish

Related product manuals