Beko BS 107 C - User Manual

Questions and Answers

J
John RoseAug 4, 2025
Why is the cooling effect not good in my Beko BS 107 C Air Conditioner?
- C
  Courtney JosephAug 4, 2025
  The cooling effect of your Beko Air Conditioner might be poor due to several reasons. Direct sunlight can affect cooling, so try pulling the curtain. Open doors or windows, too many people in the room, or other heat sources can also impact performance; close doors and windows to improve cooling. A dirty filter screen can restrict airflow, so clean or replace it. Finally, check if the air inlet or outlet is blocked and clear any obstructions.
G
Gary CharlesAug 12, 2025
What to do if the Beko BS 107 C Air Conditioner remote control does not work?
- L
  Lori NunezAug 12, 2025
  If the remote control for your Beko Air Conditioner isn't working, first ensure that you are close enough to the air conditioner and that the remote control directly faces the remote control receiver. If that doesn't work, replace the batteries in the remote control.
G
George CastroAug 18, 2025
How to fix a Beko BS 107 C that does not work?
- B
  beckywilliamsAug 18, 2025
  If your Beko Air Conditioner isn't working, first ensure it's properly connected to a socket with electricity and turned on. If the overflow indicator displays “FL”, discharge the water inside. The unit should be used at the temperature of 7-35°C (44-95°F). Also, in cooling mode, check that the room temperature isn't lower than the set temperature, and in heating mode, that it isn't higher; adjust the set temperature accordingly. Finally, in dehumidification mode, ensure the room temperature is greater than 17°C (62°F).
L
Lance RussellAug 27, 2025
Why does the compressor not work on my Beko BS 107 C?
- H
  heather68Aug 27, 2025
  If the compressor of your Beko Air Conditioner isn't working, it might be due to overheat protection being activated. Wait for 3 minutes until the temperature is lowered, and then restart the machine.

Summary

Safety Instructions

Transportation, Marking, and Storage

Control Settings

Control Panel Operation

Remote Control Operation

Installation and Adjustment

Unit Installation Guide

Step-by-step guide for installing the air conditioning unit, including heat pipe and window sealing.

Drainage Instructions

Manual Drainage Procedure

Continuous Drainage Option

Troubleshooting

Common Operational Problems

Identifies common issues like unit not working, poor cooling, or noise, with their causes and solutions.

Remote Control and Error Displays

Addresses problems with the remote control not working and error displays like 'E1' or 'E2'.

Servicing and Repair Safety

Safety measures for servicing equipment with flammable refrigerants, including area checks and procedures.

Component Repair and Cabling

Guidance on repairs to sealed components, intrinsically safe components, and cabling integrity.

Refrigerant Handling and Leak Detection

Procedures for detecting leaks, removing, evacuating, and charging refrigerant safely.

Decommissioning and Labelling

Steps for safely decommissioning the unit, recovering refrigerant, and proper labelling.

Installation Instructions

F-Gas Regulations Compliance

Specifications

Technical Specifications

Beko BS 107 C Specifications

General

Cooling Capacity	10000 BTU/h
Energy Efficiency Class Cooling	A
Refrigerant	R410A
Weight (Indoor Unit)	8 kg
Operating Temperature (Cooling)	18°C to 43°C
Dimensions (Outdoor Unit)	700 x 245 x 540 mm